Publicidad
Idiomas disponibles
Idiomas disponibles
Refilling the water tank
c)
Which water to use:
The iron can be used with tap water, but if you live in a region where the water is very hard, mix
untreated tap water with distilled or demineralised water in the following proportions: -50% tap
water, -50% distilled or demineralised water.
1.
Ensure that the iron is unplugged and that the temperature control button is set to Min
(minimum
2.
Open the water filling hole on the front of the handle.
3.
Hold the iron at a 45° angle and fill the water tank (do not exceed the maximum level
indicated on the side of the iron) using the water measuring container provided.
4.
Close the lid of the hole.
-
Do not put any objects in the water tank.
-
Do not add water when ironing or when the iron is hot.
A special non-removable filter installed in the tanks softens the water and prevents the
accumulation of limescale on the soleplate.
3) USING YOUR IRON
a)
Dry ironing
1.
Put the iron in the vertical position.
2.
Set the continuous steam slider to "0".
3.
Plug the lead into an earthed power socket.
4.
Adjust the thermostat to the fabric to be ironed.
5.
The water may remain in the water tank when dry ironing.
6.
Once connected to the power supply, the red LED starts to flash.
7.
When the red LED switches off, this means that you can start to iron.
Check the washing label to know which temperature to use for each item of
clothing.
19
Publicidad
