Publicidad
Idiomas disponibles
Idiomas disponibles
3. Move the throttle lever/rod to approximately 1/4 of its full travel (25% throttle), as indicated in the following figure;
4. To start a cold engine, move the choke lever to the CLOSED position.
- To restart a warm engine, leave the choke lever in the OPEN position.
If the choke lever was moved to the CLOSED position to start the engine, gradually move it back to the OPEN position as the engine warms up.
CLOSED
Note: This can change its physical appearance and position depending on the machine, including the direction for opening or closing, so pay attention
to the signs containing information regarding actions, movements and directions.
ATTENTION: Step 4 is valid only in cases of cold start, in case of hot start, disregard this step, that is, it is NOT necessary to activate the choke. In cases
where the engine is at an "average temperature" to the point that it does not fit into any of the starting categories, that is, hot or cold, open the choke
in order to have 50% of its actuation, soon after, just follow the instructions for the other steps as normal.
ACCELERATING
ATTENTION: If this value is exceeded (25%), there is
a risk that, when starting the engine, it will have
enough capacity to make the machine work without
the operator being prepared to start operations, a
SLOWING DOWN
fact that can result in accidents or damage to the
machine.
13
OPEN
Publicidad
