Assembly - Norge LL7WS2 Manual Del Operador

UNPACKING
See Figures 4 - 5, pages 16 - 17.
This product requires assembly.
 Carefully lift the saw from the carton and place on a level
work surface.
WARNING:
Do not use this product if any parts on the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ-
enced the settings, refer to specific procedures explained
in this manual.
 If any parts are damaged or missing, please call
1-800-427-3966 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.

ASSEMBLY

INSTALLING MOTOR HEAD ASSEMBLY TO
WATER TRAY FRAME
See Figure 6, page 17.
 Align the holes in the motor head assembly with the holes
on the side of the water tray frame.
 Insert large and small socket head screws and finger
tighten.
 Using the hex key, securely tighten the large socket head
screws on the side of the water tray frame.
 Tighten the small socket head screws last.
INSTALLING SPLASH GUARD
See Figure 7, page 17.
 Align the hole in the splash guard with the hole in the
back of the motor head assembly.
 Using the flat washer and screw, secure the splash guard
in place.
INSTALLING WATER SUPPLY VALVE TO THE
WATER TRAY
See Figure 8, page 18.
 Unscrew the water supply valve cap.
 Place the water supply valve into the hole in the water
tray as shown.
 Screw the water supply valve cap onto the threaded end
of the valve and tighten securely.
INSTALLING TILE SAW TO THE WATER TRAY
See Figure 8, page 18.
 Carefully place the water tray frame inside the water tray.
Saw head assembly goes to the back of the frame where
the hose connections are located.
INSTALLING CLEAR HOSE TO WATER SUPPLY
VALVE
See Figure 9, page 18.
 Attach the clear hose into the water supply valve con-
nection on the inside of the water tray.
 Secure hose with clear hose clamp.
TILE CUTTING WHEEL
For maximum performance and safety, it is recommended
that you use the 7 in. cutting wheel provided with your
saw. Additional cutting wheels of the same high quality are
available at your local dealer.
WARNING:
Do not use cutting wheels rated less than the no load
speed of this tool. Failure to heed this warning could
result in personal injury. Do not use wheel with cracks,
gaps, or teeth.
8 — English