Publicidad
Idiomas disponibles
Idiomas disponibles
Identification mode
List of screens used to enter a repair order :
If a repair order has already been created, it cannot be changed or deleted on the machine. To delete it, use the Gyspot software on the PC. The user
can create a maximum of 100 repair orders.
Repair order
Vehicle make
The arrow keys (
field. Press the
Catalogue
GYSPOT PTI S7
If the identification mode is set to «ON», all mandatory fields in the repair order must be entered to
allow the weld to go ahead or the machine will display «identification fault».
To activate and deactivate the identification mode, an SD identification card must be inserted in the
BP card reader instead of the SD card containing the programs.
The settings screen is activated by pressing and holding down the
When the SD card «identification» is inserted and «identification ON» is selected, the supervision
screen is displayed.
This screen is used to make the fields «registration, vehicle make, vehicle model, vehicle model,
chassis number» mandatory fields when entering the repair order.
To exit the screen, press the
containing the programs back into the machine card reader.
User identification
Vehicle model
or
) are used to change the letters or numbers. The keys - and + are used to move the cursor inside the
button briefly to clear the field. The
The
button is used to consult the repair orders. The page number is displayed (max. 13)
The keys - and + are used to change pages. The keys
job. The
button displays the selected repair order.
The
button key is used to exit the report view mode.
button for 2 seconds. Then, it is necessary to put the SD card
button allows you to scroll through the fields for editing or reading.
et
EN
button for 2 seconds.
Registration (optional)
Chassis number (optional)
are used to select previous or next
45
Publicidad
