Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
8
Making the water supply
connections
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
other and damaging.
□
Thread the nut (1) on the supply line onto the
outlet of the water supply valve (2) and tighten
with a wrench. Do not overtighten.
Operation
1
Flushing and checking for leaks
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
□
Ensure the faucet (A) handle is in the off
position, and turn on the water supply to check
for leaks. If you discover any leaks, check your
connections to ensure they are installed properly.
□
Pull the hose assembly out of the spout and
remove the aerator (1) by unscrewing it from the
hose in a counterclockwise direction. Be sure to
hold the end of the hose down into the sink and
turn the faucet to the warm position where it
mixes hot and cold water. Flush the water lines
for one minute. This ushes away any debris that
could cause damage to internal parts.
□
Re-tighten any connections if necessary, but do
not overtighten. Reinstall the aerator by hand
tightening it back onto the hose in a clockwise
direction.
1
2
7
Please contact 1-855-HD-GLACIER for further assistance.
A
1
HOMEDEPOT.COM
Publicidad
