Burris BTC35 v2 Manual De Usuario página 27

Storage and Maintenance
When the BTC will be not used for a long time, store it in
a dry, well-ventilated environment. The infrared lens of the
thermal imager is coated with an anti-reflection film. Clean
the lens only when dirt or smudges are present. Frequent
scrubbing may damage the lens coating. To clean non-
optical surfaces of the BTC, do not scrub with chemical
solvents or cleaners. On exterior surfaces, wipe with a soft
and dry microfiber cloth.
Coarse dirt/debris must be removed from the lens surface.
The most convenient way to clean a lens surface is to use a
Lens Pen. Position the scope so particles will fall away from
the lens, and then use the Lens Pen or soft brush to gently
whisk away the debris while blowing on the lens to dislodge
the particles. Canned air or an air compressor will help
clear off any dust particles. For heavy dirt, like dried mud,
use a spray of clean water or lens cleaning fluid to remove
the dirt.
Common Fault ICONS and
Troubleshooting
If your BTC has performance issues, the troubleshooting
chart on the next page will solve most problems. If these
suggestions do not solve the problem, contact Burris
Company for service or repair.
IMAGE CALIBRATION COMPLETE
WI-FI IS ON AND DEVICE IS CONNECTED
WI-FI IS ON AND DEVICE IS NOT CONNECTED
WI-FI DISABLED
SUPER ENERGY SAVING MODE ACTIVATED
SCREEN BRIGHTNESS ADJUSTMENT DISABLED
SUPER ENERGY SAVING MODE ACTIVATED
EXTREMELY LOW BATTERY WARNING
SHUTDOWN IMMINENT
27 | BURRIS THERMAL RIFLESCOPE USER MANUAL