Snakebyte DUAL CHARGE & HEADSET STAND 5 Manual De Instrucciones página 3

EN
DUAL CHARGE & HEADSET STAND 5™ for PS5™
PRODUCT INFORMATION
Thank you for choosing snakebyte's DUAL CHARGE & HEADSET STAND 5™. Please read this guide for important
safety and health information and retain it for future reference.
CONTENT
1 x DUAL CHARGE & HEADSET STAND 5™
1 x Charging cable 15 cm USB-A to USB-C
1 x Charging cable 15 cm USB-A to Micro USB
1 x Charging cable 100 cm USB-A to USB-C
OPERATING INSTRUCTION DUAL CHARGE & HEADSET STAND 5™
- Plug the power supply into the charger, the orange and blue lights will be on for 1 second for self-checking, and
then turn off after self-checking. If there is overvoltage or low voltage in the input power supply, the orange LED
light flashes quickly to give an alarm, and the input power supply needs to be disconnected and check the power
supply. Then reconnect to restore the charger function.
- Put the controller into the charger socket, if the controller needs to be charged, the orange LED light will be on,
indicating that it is charging; if the controller is fully charged, the orange LED light will be off, and the blue LED light
will be on, indicating that the charging is fully charged.
- Use the charging cable to connect the headset. If the headset needs to be charged, the orange LED light is on,
indicating that it is charging; if the headset is fully charged, the orange LED light is off, and the blue LED light is on,
indicating that the charging is fully charged. (If the power status of the connected headset is fully charged, the
orange light will be off and the blue light will be on after the charger charges it for 15 seconds approximately.)
- Input overvoltage and undervoltage protection function, if the input power supply voltage is greater than 5.7V, the
orange LED fast light flashes, overvoltage alarm, the charger will stop charging immediately; if the input power
supply voltage is less than 4.2V, the orange LED fast light flashes, Undervoltage alarm, the charger will stop
charging immediately. After overvoltage and undervoltage protection, it is necessary to disconnect and check the
power supply. Then reconnect to restore the charger function.
- Output overvoltage protection function, if the voltage of the charging output terminal is greater than 5.7V, the
orange LED flashes quickly to alarm, the charger will stop charging immediately, and the input power needs to be
disconnected and check the power supply. Then reconnect to restore the charger function.
- The maximum allowable load current of the charging port of the handle is 1500MA. If the load exceeds 1500MA,
the orange LED light flashes rapidly, and the charging port is over-current protected, and there will be no voltage
output. It is necessary to disconnect and check the power supply. Then reconnect to restore the charger function.
- The maximum allowable load current of the charging port of the headset charging is 800MA. If the load exceeds
800MA, the orange LED light flashes rapidly, and the charging port is over-current protected, and there will be no
voltage output. It is necessary to disconnect and check the power supply. Then reconnect to restore the charger
function.
- If the headphone is left connected to the charger for a longer period after its batteries are fully charged,
the charging status indicator light may switch off.
TROUBLE SHOOTING
THE CONTROLLER IS NOT CHARGING:
- Make sure the DUAL CHARGE & HEADSET STAND 5™ controller is firmly placed on the charging plug.
- Make sure DUAL CHARGE & HEADSET STAND 5™ is connected to USB power supply.
- Make sure the connected USB power supply is plugged in.
THE HEADSET IS NOT CHARGING:
- Make sure the headset is firmly connected to the charging cable.
- Make sure DUAL CHARGE & HEADSET STAND 5™ is connected to USB power supply.
- Make sure the connected USB power supply is plugged in.