Garland XTRIM 365 E Manual De Instrucciones página 31

6. START UP INSTRUCTIONS
6.1. LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Machine.
• Guard.
• Guard screws (x2).
• Wheel guide.
• Instructions manual.
Carefully remove all items from the box and make
sure that all listed items are present.
Inspect the product carefully to ensure that there are
no damaged elements. If you find any damaged or
missing parts, do not use the machine until the defect
has been repaired or until you havve all the necessary
pieces of which the device consists. Using the
machine with defective or missing pieces can cause
severe personal injury.
6.2. ASSEMBLY
6.2.1. ASSEMBLY OF THE GUARD
Place the guard as shown in the figure.
Insert the 2 screws and tighten.
6.2.2. ASSEMBLY OF THE WHEEL GUIDE
Install the wheel guide by screwing the clamp 2
screws to the front of the guard.
6.2.3. CHANGING THE NYLON STRING
Remove the bottom cover (1) by pressing the 2 tabs.
Remove the empty spool from its notch and remove
all the remaining thread.
Cut approximately 4 meters of nylon yarn.
Take the tips of the thread, fold it in half, then insert
it into the notch of the spool (2) and wrap the 2 tips
of the thread in the same direction each in their
corresponding lane
Block the tip of each
thread in the two
grooves (3).
31/124
English
1
3
3
2