Publicidad
Idiomas disponibles
Idiomas disponibles
6. Operating
To operate, plug the pump (A) into a GFCI outlet.
NOTE:
This pump can be very loud when plugged in. THIS IS NORMAL.
Once water begins to pump, the noise will dissipate. When the water level
has been reduced to approximately 1/8 in. you MUST UNPLUG THE
PUMP. DO NOT RUN DRY. The pump will be EXTREMELY LOUD when
the pump is no longer pumping water.
NOTE
: If water is not pumped in 30 seconds, unplug the power cord and
check the connection on the two ends of the inlet hose to make sure there
are no air leaks. Then, add water into the inlet again and repeat the
process.
CARE AND CLEANING
Do
When the power is disconnected, inspect the
pump suction screen and remove all debris,
then plug the pump back into the grounded
(GFCI) outlet.
If the pump is not running properly
Remove the impeller cover screws (#1),
Remove the impeller cover (#2),
Inspect the O-ring/gasket (#3) and impeller (#4). If the impeller wears out, replace the impeller. The brushes could
run 200 hours. If the brushes have been worn off, replace the brush as the picture shows.
The brush must enter the square hole. Match the brush curve to the armature curve.
If there are any damages to these parts, please contact the pump experts at 1-844-242-2475.
NOTE: Do not disassemble the motor housing of the pump. This motor has NO repairable internal parts, and
disassembling may cause a dangerous electrical wiring issue.
For Professional Technical Support call 1-844-242-2475
Do Not
Do not disassemble the motor housing. This motor
has NO repairable internal parts, and disassembly
may cause leakage or dangerous electrical wiring
issues.
Do not lift up the pump by the power cord.
5
Publicidad
