SNOWJOE sunjoe SWD5000 Manual Del Operador página 10

Fig. 9
Lid lock
2. To attach the power head, insert the tabs on each side of
the collection tank into the lid lock slots, and push firmly
to make sure the tabs are locked inside of the lid locks.
NOTE: The power head must be attached any time the
unit is being operated.
Maintenance
To order genuine replacement parts or accessories for the
Sun Joe SWD5000 electric wet/dry vacuum, please visit
®
sunjoe.com or contact the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
Disconnect the power cord before
performing any maintenance task.
If the power is still connected, the unit could be accidentally
turned on while you are performing maintenance on it,
which could result in personal injury.
Cleaning The Dust Tank
Clean the equipment routinely after each use:
1. Take the unit outside to clean it to avoid creating a
mess indoors.
2. Remove the power head and empty the dust tank.
Clean the tank with water and allow it to dry completely.
Cleaning the HEPA filter
m
WARNING!
To avoid serious personal injury, always
turn the unit off and unplug it before cleaning or servicing.
The HEPA filter included is made of high quality material
designed to stop small dust particles. The filter should be used
for dry pick-up only. If the dust filter is wet, it will clog quickly
and be very difficult to clean. Handle the filter carefully when
removing it for cleaning and replacing. Check the filters for
tears or small holes, a small hole can let dust pass through
and out of the cleaner. Do not use a filter with holes or tears,
replace it immediately.
1. Switch off and unplug the unit.
2. Remove the power head from the collection tank.
Power head
+ Sun Joe customer
® ®
10
3. With the removed power head in the upside down
position, carefully remove the HEPA filter from the filter
cage (Fig. 10).
Fig. 10
HEPA filter
4. Clean the HEPA filter by gently tapping or brushing dirt off.
Cleaning should not be done indoors in living areas.
5. If needed, use a mild soap and water solution to wash the
HEPA filter and rinse with clean water. Allow the wet filter
to air dry for 24 hours before installing onto the filter cage.
m
WARNING!
The HEPA filter must be installed before dry
vacuuming again.
Cleaning the Foam Filter
m
WARNING!
The foam filter must be cleaned every time
after wet vacuuming.
1. Switch off and unplug the unit.
2. Remove the power head from the collection tank.
3. With the removed power head in the upside down
position, carefully remove the foam filter from the filter
cage (Fig. 11).
Fig. 11
4. Use a mild soap and water solution to wash the foam filter
and rinse with clean water. Allow the wet filter to air dry for
24 hours before installing onto the filter cage.
5. To assemble the filter, fit the foam filter on the filter cage
(Fig. 12).
Foam filter