Publicidad
Idiomas disponibles
Idiomas disponibles
Service
• Tool service must be performed only by the MATCO authorized
service centers listed . Service or maintenance performed by
unqualified personnel may result in a risk of injury . Repair by
unqualified personnel, use of unauthorized parts, and failure to
follow maintenance instructions may create a risk of shock or
injury .
SAVE THESE INSTRUCTIONS!
SPECIFIC SAFETY RULES
DO NOT let comfort or familiarity with product replace strict
adherence to cordless product safety rules. If you use this
tool unsafely or incorrectly, you can suffer serious personal
injury.
• Hold tool by insulated gripping surfaces when performing an
operation where the accessories may contact hidden wiring .
Contact with a "live" wire will also make exposed metal parts of
the tool "live" and shock the operator .
OPERATING INSTRUCTION
Installing Or Removing Battery Pack
1 . Your new battery pack is not fully charged . You may need
to charge before use .
2 . Make sure the forward/reverse lever is in the neutral
position when installing or removing a battery .
3 . To remove a battery, depress the front tab and pull the
battery forward and the tool in the opposite direction .
4 . To install a battery align the tool with the battery, place the
front of the tool about halfway up the battery, push forward
until click is heard indicating full installment .
Charging The Battery Pack
1 . Battery may not charge when it is above a certain preset
temperature limit . Allow temperature of battery to cool before
charging .
2 . The charge process will take less than one hour .
3 . After charging, unplug the charger from the power source
and stow away in a safe place .
Tool Operation
1 . Turn the hand chuck collar counterclockwise to loosen
while holding the chuck handle still . Insert the bit and center
into the chuck . Turn the chuck collar clockwise to tighten and
make sure that the bit is firmly held within the chuck .
2 . Run the tool to ensure tightness before placing the tool
and bit onto work .
3 . Forward and reverse switch is actuated by a sliding
mechanism located above the handle .
4 . Select the appropriate torque setting on the dial clutch .
MCL2012BDD
MCL2012BDD 20V
+
1/2" Brushless Drill Driver
• Be aware that this tool is always in operating condition,
because it does not have to be plugged into an electrical outlet .
• Always be sure you have firm footing .
• Be sure no one is below when using the tool in high locations .
• Hold the tool firmly and use both hands .
• Keep hands and hair away from rotating parts .
• Do not leave the tool running . Do not force tool to stay in the
"on" position . Operate the tool only when hand-held .
• Do not touch the impact socket or the workpiece immediately
after operation; they may be extremely hot and could burn your
skin .
• Some material contains chemicals which may be toxic . Take
caution to prevent working dust inhalation and skin contact . Follow
material supplier safety data .
WARNING:
MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
How to use MCL2040LB with 20V
(released in 2019)
20V
+
BRUSHLESS Matco tools will function normally when
using the MCL2040LB battery . Since the connection styles
are different it is required to utilize the adapter MCL20BADP .
Connect the adapter to the BRUSHLESS tool then slide the
MCL2040LB battery in place until a click is heard and the
release buttons locks into place .
FAQ
Question: Can I use the adapter (MCL20BADP) connected to the
MCL2040LB battery and charge it on the MCLCHRG6?
Answer: No . The adapter does not have the proper circuitry
to allow it to be used to charge the battery . To charge the
MCL2040LB remove the adapter and utilize the MCLCHRG5 or
MCL1840CHRG .
3
+
Brushless Tools
rev. 02/22/19
Publicidad
