mspa Lite LS042-NA Manual Del Propietário página 14

Storage and Preparation for Future Use
1. Drain and clean the spa by following the "Drainage" and "Spa Cleaning" sections.
2. Refer to the instructions to deflate the spa tub and air bladder (*Optional).
3. Make sure all the spa components and accessories are thoroughly clean and dry before
storage. Air-dry the spa tub in mild sunlight for an hour before folding.
4. Fold the spa tub loosely and avoid any sharp corners to prevent damage or leakage to
the spa liner.
5. Prepare a new additional cartridge for next time use.
6. Store the spa and accessories in a dry, temperature-controlled storage area
(between 0°C and 40°C (32°F - 104°F).
7. The original packaging is recommended for storage.
PRECAUTIONS FOR SEASONAL USE
Inflatable hot tubs are made of reinforced PVC material, whose nature decides the hot tubs are easily affected by weather and temperature. Please do pay
special attention when using the spa under different seasonal conditions.
In Summer / Sunny days
Direct sunshine and hot weather will both lead the spa liner to expand.
●
To extend the service life of the spa, it is suggested to place the spa in a sheltered place.
●
Please check the air pressure regularly. The manometer should always point to the Green section when spa is filled with water. When leaving the spa
outdoors unattended for long periods of time, release some air until the manometer points to the Yellow section. This will prevent the spa liner from
expanding too much due to rising temperature during the daytime.
●
To protect your skin from sunburn, it is highly recommended to enjoy the spa in the morning or evening when the sunlight is milder and temperature is
more comforting.
●
Check the water temperature and consider lowering it for the times when the spa is not in use. Turn off the heater entirely if not using the spa for an
extended period of time.
In Winter
Inflation
Low temperature will harden the PVC material and make it more fragile.
●
The new spa might have been stored or transported at a low temperature (below 4°C / 39°F) before it is unfolded. Put the package indoors or
somewhere warm for 12 hours to soften the material before use.
●
The lower the temperature is, the more air the spa tub will require, and the longer the inflation will take. After water is heated to a much higher tempera-
ture, the air inside the chamber will get swollen. To shorten the inflation period, and to reduce the expansion of the spa liner, we suggest inflating the spa
at a temperature higher than 15°C / 59°F. If the ambient temperature is below 0°C / 39°F, the spa should not be inflated.
Heating and Heat Preservation
In cold weather, heating the water up will take much more time. It is suggested to:
●
Fill the spa tub with lukewarm water (not higher than 40°C / 104°F) to get it heated it more quickly.
●
Use ground mat and inflatable bladder (*Optional) for better heat preservation effect.
●
When the outdoor temperature is below 4°C(39°F), even when not using the spa, as long as it is filled with water, the heater should always be turned on
(or put the spa in stand-by mode) to prevent water from freezing.
●
Your spa is equipped with an Anti-icing System. Put the spa in stand-by mode, when the water temperature falls below 1°C/33.8°F, the heater runs
automatically until the water is heated up to 3°C/37.4°F. This will help prevent water from freezing. If you are not going to use the spa in near future，
please disassemble the spa and store it following the storage procedure.
In Rainy days
For the spa that is placed outdoors, do not use it when it rains.
If the spa is placed under rain shelter, do not turn on the bubble function. This is because the rain in the nearby air will also be sucked into the pump,
causing the bubble generator to get damp and rusty which could result in malfunction and void your warranty.
It is recommended to put the plug and socket somewhere not exposed to rain to prevent damage caused by water accumulation due to excessive rain.
14