IIi[tl,_l
Strike
long
arm
of
wrench
sharply
counterclockwise,
remove
wrench
and
unthread
chuck from spindle.
INSTALLING
CHUCK
Always
keep the spindle threads,
the threads
of the chuck
and securing
screw
free
of
debris. To install a chuck,
reverse
"removing
the chuck" procedure.
RELEASING
AND INSERTING
BATTERY
PACK
Release
battery
pack from tool by pressing
pack. To insert battery, align battery and slide
on both sides of the battery
release tabs and
battery
pack
into
tool
until
it locks
into
pull
downwards.
Before
inserting
battery
position. Do not force.
pack,
remove
protective
cap from
battery
IMPORTANT CHARGING NOTES
1.
The
battery
pack
accepts
only
about
80% of its maximum
capacity
with its
first few charge
cycles.
However,
after the
first
few charge
cycles,
the
battery
will
charge
to full capacity.
2. The charger
was designed
to fast charge
the
battery
only
when
the
battery
temperature
is between
40°F
(4°C)
and
105°F (41 °C).
3. A substantial
drop
in operating
time per
charge
may
mean
that the battery
pack
is
nearing
the end of its life and should
be
replaced.
4.
If you anticipate
long periods (i.e. a month
or more) of non-use
of your tool, it is best to
run your tool down until it is fully discharged
before storing your battery pack. After a long
period of storage, the capacity at first recharge
will be lower. Normal capacity will be restored
in two or three
charge/discharge
cycles.
Remember
to unplug charger
during storage
period.
5. If battery does not charge
properly:
a. Check for voltage
at outlet by plugging
in some other electrical
device.
b. Check to see if outlet is connected
to a
light
switch
which
turns
power
"off" when
lights are turned off.
c. Check
battery
pack terminals
for dirt.
Clean
with
cotton
swab
and
alcohol
if
necessary.
d. If you still do not get proper
charging,
take or send tool, battery
pack
and charger
to your
local
Bosch
Service
Center.
See
"Tools,
Electric"
in the Yellow
Pages
for
names and addresses.
Note:
Use of chargers
or battery
packs
not
sold by Bosch will void the warranty.
-10-