Descargar Imprimir esta página

ProBreeze PB-D-23 Manual De Instrucciones página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 53
Do not place the continuous draining hose when the
temperature falls below 1
This appliance is intended for indoor household use and
similar applications. Do not use outdoors.
Do not use the appliance near petrol, paints, flammable
gases, ovens, or other heating sources.
The mains cable should not hang down from the surface
on which the appliance is placed in order to prevent the
appliance from being pulled down.
To avoid a circuit overload when using this appliance,
do not operate another high-wattage appliance on the
same electrical circuit.
Always plug the appliance directly into a wall socket.
Avoid using extension leads where possible as they may
overheat and a cause a risk of fire.
Do not use this appliance with an external programmer,
timer switch or any other device which would switch the
appliance on automatically unless this has already been
pre-built into the appliance by the manufacturer.
Do not pull on the power cord. Never move, carry or hang
the appliance by the power cord.
Do not kink or wrap the power cord and plug around the
appliance, as this may cause the insulation to weaken or
split, particularly where it enters the appliance.
Do not operate the dehumidifier with the water tank
removed.
Ensure the mains cable is fully extended before use and
arrange it so that it is not in contact with any part of the
dehumidifier.
Do not operate the dehumidifier if there are signs of
damage to the dehumidifier, power cord, or any of the
accessories supplied. If the supply cord is damaged, it
must be replaced by the manufacturer, its service agent
or a similarly qualified person in order to avoid a hazard
Do not operate the dehumidifier with any safety guards
removed.
Do not attempt to repair or adjust any electrical or
mechanical elements in the dehumidifier. Doing so may
be unsafe and will void your warranty.
C.
o
English | 5 of 104

Publicidad

loading