Scheppach TIGER 2500 Traducción Del Manual De Instrucción Original página 27

After you have set the angle, insert the tool mounted in
the device on the universal support, turn on the motor,
and start the grinding process. Press the tool even-
ly onto the grinding stone near the cutting edge, and
move it crosswise across the stone. Please make sure
that at least half the width of the cutting edge comes
into contact with the grinding stone at any time to avoid
damages of the stone.
To achieve finer grinding results, prepare the stone
using the Stone preparer. Thereby you increase the
graining from 250 to approximately 1000. The SP is
available as an accessory from your Scheppach deal-
er.
Sharpening (Fig. 8)
Never sharpen against the direction of grinding! Other-
wise, the tool will cut into the leather!
Impregnate the leather disc using weak machine oil.
Then apply abrasive paste on the leather disc. Turn
on the device, and distribute the abrasive paste by
pressing the ground tool with circular movements on
the wheel.
These preparations are sufficient for five to ten tools.
Then, you start again with a new layer of machine oil,
followed by new abrasive paste. These measures in-
crease the lifetime of the leather and the quality of your
tools.
Expert tip: You can work in the free-handed mode for
the trimming itself. You achieve a more precise result if
you keep the tool in the device in the position in which
you ground the tool.
11. Cleaning and maintenance
m Warning!
Switch off the machine and pull out the mains plug be-
fore performing setting, maintenance or service work!
Cleaning
Keep all safety devices, ventilation slots and the en-
gine housing free from dirt and dust insofar as possible.
Wipe the device clean with a clean cloth or blow it off
with compressed air at low pressure.
We recommend cleaning the device immediately after
each use.
Maintenance
The device has no further internal parts that require
maintenance.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and tear, and are
therefore also required as consumables.
Wearing parts *: Grindstone, honing paste, leather
honing wheel, angle gauge, friction wheel
* May not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
12. Storage and transport
Store devices and accessories out of the reach of chil-
dren in a dark and dry place above freezing point. The
optimum storage temperature lies between 5 and 30
°C. Store the power tool in its original packaging. Store
the grindstone in a cool, dry and dark place.
m Attention!
It is essential that the device is secured against falling
or tipping over during transport.
The machine may only be lifted and transported by its
frame.
13. Electrical connection
m The electric motor installed is connected and ready
for operation.
The connection complies with the applicable VDE and
DIN provisions.
The customer's mains power connection as well
as the extension lead used must also comply with
these regulations and the local electricity supplier
regulations.
Damaged electrical connection cables
The insulation on electrical connection cables is often
damaged.
Possible causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
www.scheppach.com GB | 27