Publicidad
Idiomas disponibles
Idiomas disponibles
InltJal
Use
To reach the set coldness level when operating the beverage center for the first time, run it without
load until you hear the compressor stop. This usually takes 2 to 3 hours Once the set temperature is
reached, load beverages into the beverage center
Note:
If the beverage cehqter has been placed in a horizontal or more than 45 °
tilted position for any period of time,wait 1 hour before plugging it in,
Temperature Control
Temperature Adiustment
fn, : Pressthispad once and the temperature will increase 1° F/C.
V
: Pressthispad once and the temperature will decrease 1 ° F/C
The beverage center can be operated by adjusting the temperature control buttons (up arrow
and down arrow/ to various settings.
The new desired temperature will flash on the display for a few seconds and then switch
back to the actuat temperature which will gradudiy change unfit setpoint is reached.
The temperature range MIN and MAX is 40 °- 50°F (4°, 10°C}, which is ideal for
beverage storage.
_LED
light pad; press to turn light on or off.
POWEROn/OF: Pressthis pad to power the unit on or oF.
and POWER_ogether for 2 seconds to convert between Fahrenheit
Press
tempera tare and Cetsinstemperature.
Failure Codes
If "E" and "F"display.,contact Sears or another qualified service center for unit repair.
If the temperature inthe beverage center istoo Jaw,it wilt display "LtL Adjust the temperature
control to a warmer setting
nfthe temperature in the beverage center istoo high, the control wilt flash "H", and an alarm wilt
sound for 30 seconds. One minute tatec the alarm witi continue to sound for another 30 seconds.
After three times,the alarm witl not sound any more You can press any key to cancel the sound
atarrn.
Storing too many cans or bottles in the beverage center may cause the temperature inthe chiller to
rise tempora rily.
Normal Operating Sounds You May Hear
At times you may hear boiling water, gurgling sounds, etc. that are the result of the
refrigerant circulating through the cooling coils
Cleaning
and Maintenance
WARNING:TO avoid electric shock,always unplug your beverage center before
cleaning. Ignoring this warning may resultin death or iniury.
CAUTION.. Belore using cleaning products, always read and understand the cleaning processes
explained in this manual. Follow cleaning product manufacturers's instructionsand warnings to avoid
personal injury or product damage.
General Cleaning
Prepare a cleaning solution of 1to 2 tablespoons of baking soda mixed with warm water, Usea
spongeor soft cioth, dampened with the cleaning solution,to wipe down your beverage center
and Temperature Contro! panel
Rinsewith clean warm water and dry with a soft cloth.
Do not use harsh chemicals, abrasives, ammonia, chlorine bleach, concentrated detergents,
solventsor metal scouring pads. Some of these chemicals may dissolve, damage and/or discolor
your beverage center.
Door Gaskets
Clean door gaskets every three monthsaccording to the instructions described above in General
Cleaning.
Apply a light coating of petroleum icily to the hinge side of the door gaskets to keep the gaskets
pliable and ensurea good seal.
Power interruptions
Occasionally there may be power interruptions due to thunderstormsor other causes Removethe
power cord plug from the AC outlet when a power outage occurs. Keep the beverage center door
closed to preserve compartment coolness for as long as possibie After a prolonged power outage,
you should clean the inside of the beverage center compartment before reuse.
Vacation and Moving Care
Forlong vacationsor absences,unplug the unit, remove beverages from beverage center,turn
the temperature dial to the OFF positionand clean the door gasketsaccordingto the General
Cleaning section.Propdoor open, soair can circulate inside,if moving ihe beverage cemer,
always keep it in a vertical position Donot moveunit whenina horizontalposition,aspossible
damageto the sealedsystemcould occur.
9
618110
Publicidad
