Descargar Imprimir esta página

Sinbo SK 2395 Manual De Instrucciones página 15

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 31
RE-BOIL THE HOT WATER UNDER THE KEEP WARM MODE.
• Re-boiling a full container takes about 3 minutes.
• Before Re-boiling,make sure the water level is above the refill mark.
• The Re-boil key may have no effect right after the water has boiled.
• When adding water to the Air pot ,be careful not to get bumty hot steam as you open
the top lid.
• Once the Re-boil button is pressed,the boiling process cannot be reset until the Thermo
Flask.Automatically switches to the keep warm mode.
• Do not press the Re-boil button repeatedly,as the continuous oiling process will cause
malfunction.
AFTER USE
Unplug the power cord
Remove the lid and
Dispose the water.
• Allow the Thermo Flask to dry thoroughly.
• Do not place the Air pot in a dishwasher or dish dryer,This will damage the Air pot.
• If not in use,seal in a plastic bag to protect it from dust and insects.
Cleaning And Maintenance
1. Always allow appliance to cool before cleaning.
2. Remember to unplug power cord from wall socket and power inlet.
3. Detach upper lid and pour out remaining water.
4. If mincral deposits are allowed to accumulate,loud noises may be heard during boiling
and you may face diffculties dispensing hot water.Regular cleaning will avoid such
problems.
Wipe upper lid and body with a damp cloth.
• Never immerse any part of the Thermo Flask in water.
• Never splash water on the operation panel.
• Do not use abrasive materials to clean appliance.
Discoloration of the inner container and white particles floating in the water.
• Red rust-like spots,milky or black discoloration,and white floating objects
are caused by minerals in the water and are not caused by discoloration
or deterioration of the inner container itself.Although this is not a hygiene
problem,clean the inner container periodically.
• Cut a lemon into four pieces,wrap the lemon in the cloth and place in the inner container.
• Pour water up to the full level into the inner container.
• Boil and then retain heat for about one hour.
• Pour out the water and use a nylon brush to clean the container.
• To remove the smell of the lemon,boil water again and dispose the water.
ATTENTION BEFORE USING
-14 -

Publicidad

loading