Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Periodically, inspect the bath seat for damaged or loose components, and
ensure that all parts are secure.
Check that there are no obstructions to normal, safe operation.
To maintain appearance and good hygiene, clean periodically with a
non-abrasive cleaner or household cleaner with warm water. Rinse with
warm water and wipe dry after cleaning.
DO NOT use abrasive powders, cleaners, cloths, or scouring pads.
Wipe bath seat dry after each use.
NOTE: If any part or mechanism appears to be unsafe or damaged,
DO NOT USE THE PRODUCT. If you experience problems, please contact
Medline at 1-800-MEDLINE.
Contents
• If exposed to cold temperatures, allow contents to come to room
temperature before completing assembly. Remove contents from box.
• Ensure that all parts are present before assembling the bath seat.
Part
Identification
A
B
C
D
E
Assembly
1. Place bath seat upside down on a flat surface.
2. Place the leg frame marked with a "B" into
the groove of the seat bottom marked "B"
(Figure 1).
3. Place the leg frame marked with an "A" on top
of the "B" leg frame and into the groove of the
seat bottom marked "A" (Figure 1).
4. Insert a thumbscrew through the middle hole
at the intersection of the leg frames, but do
not fully tighten the screw (Figure 1).
5. Lay the support bars across both leg frames,
parallel to the handles on the seat bench.
Secure each end of the support bar to the
pertinent leg frame with a thumbscrew.
NOTE: DO NOT use the bath seat without the
support bars.
2
Part Name
Bath Seat
Leg Frame
Thumbscrew
Support Bar
Leg
Quantity
1
2
5
2
4
G2-201KRX1 (PIC-00303) | V2 092123
Figure 1
Figure 2
Publicidad
