Charging/Recharging Using The 120 Volt Ac Charger And A Standard Household Extension Cord; Usb Charging Port; Led Work Light - autoXS 44266 Manual Del Usuario

600 Peak Battery Amp
Jump Starter
1
3
2
4
AFTER SALES SUPPORT
800-505-8311
USA
120V AC Charger/USB Charging Port/LED
Charging/Recharging Using the 120 Volt AC
Charger and a Standard Household
Extension Cord (extension cord not
included)
The unit's on-board circuitry is a revolutionary smart
system that determines the battery voltage based on
decisions on how to charge the battery. The
keep the battery at full charge, without overcharging.
The power pack can be left connected to an outlet
1. Connect an extension cord (not included) to the 120
volt build-in plug which is on the back of power pack
(see: "1" at left). Plug the other end of the cord into a
standard 120 volt AC wall outlet.
2. Red LED (see: "2" at left) will illuminate indicating
the charging process has started.
3. Charging cycle will automatically switch to
maintaining cycle, LED will change from RED to
YELLOW (see: "3" at left)
4. The power pack can be left connected at all times
to provide maintenance charging. However, it is good
practice to check the battery periodically.
Note: The unit cannot be overcharged using this method.

USB CHARGING PORT

Plug your device's USB cable into the USB Charging
Port and power will automatically turn on and operate
normally.
Output power will automatically turn off after USB
cable or powered device is disconnected from the
Charging Port.
Note: This unit's USB Charging Port does not support
data communication. It can provide 5 volt/500mA –
2400mA DC power to an external USB cable or
powered Device.
Disconnect the USB cable powered device when it is
not in use.

LED WORK LIGHT

Turn the LED work light ON and OFF by the Light
Switch on the front panel of unit (see: "4" at left).
Make sure the LED work light is turned off when the
unit is being recharged or stored.
acs@americancustomerservice.com
USA
11