Publicidad
Idiomas disponibles
Idiomas disponibles
Water
Line installation
instructions
[_
Connect
the Tubing
to the
Refrigerator.
Before
maldng
the
connection
to the
refrigerator,
be sure the
refrigerator
power
cord
is not plugged
into the
wall outlet.
We recommend
installing a water filter if your water
supply has sand or particles that could clog the screen
of the refrigerator's water valve° Install it in the water'
line near' the refrigeratoL
a° Remove the plastic flexible cap from the water' valve.
b. Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown.
c, Insert the end of the copper tubing into the water
valve connection
as far as possible. While holding
the tubing, tighten the fitting.
d. Fasten the copper tubing into the clamp provided
to hold it in position. You may need to pry open
the clamp.
One of' the illustrations
below wii! look like the
connection
on your refrigeratoi:
_/4" Compression
_
Tubin
Clam
Ferrule {sleeve).
Nut
/'_'_,_
g
P
Refr ge=tor-..
LLF-
_,_.../
Tubing
[_ Turn the Water
On at the Shutoff
Valve.
Tighten any connections that leak.
_1 Plug In the Refrigerator.
Arrange the coil of copper tubing so that it does not
vibrate against the back of the refrigerator or against
the wall.
Push the refrigerator back to the wall,
i_] Start
the lcemaker
Set the icemaker feeler arm to the ON (down)
position. The icemaker will not begin to operate until
it reaches its operating temperature
of 15°E (-9°C.) or
below. It will then begin operation automatically
if the
icemaker feeler arm is in the ON (down) position.
Note"
The icemaker
may double-cycle
when
it first
starts, causing
some water spillage
from the icemalcer
into the ice bucket.
This is normal
and should
not
happen again,
Tubing
12
Publicidad
