DR.ÖTEK MTXE Manual De Usuario página 27

positioning is not accurate enough, you can keep the search coil
position unchanged, press the DISC / P-P key long, and exit the P-P state.
Press the DISC / P-P button again and repeat the above until the probe
moves slightly and the strongest signal becomes smaller, locking the
position of the metal target. You can mark the ground through the
center of the open tray to facilitate digging.
9. Detection tips
a)Exploration in the mineralized environment.
When the search coil scan the mineralized soil, the soil will produce an
interference signal and affect the detection. It is recommended that you
reduce the scan speed of the coil, which can significantly reduce the
impact of mineralized soil.
b)Detect on the beach.
When the detect on the wet beach, it will produce an iron-like signal. It
is recommended that you can also reduce the scanning speed of the
search coil.
c)In fact, PINPOINT is highly sensitive, and it is also an option to use it
directly for detection. In severely mineralized or salinized areas, you can
press the button to enter the PINPOINT mode where the search coil is
close to the ground, and then move the search coil slowly.
d)In places with large electromagnetic interference, you use PINPOINT
In addition, the operator needs to be reminded that both the
discrimination display and the depth display are offset due to soil
impacts during field detection.The composition, size, and oxidation of
the underground metal will also affect the display results.When the
operator chooses to exclude a certain metal or judge whether there is a
valuable metal, to fully consider these factors, do not "exclude" the
valuable metal.
Caution
1)In busy traffic places, please do not use headphones in case of
23