Publicidad
Idiomas disponibles
Idiomas disponibles
1
INSTALL RISER TUBES TO VALVE BODY
Turn off hot and cold water
CAUTION
supplies before begining.
• Insert RISER TUBE (1) without the flange over SUPPLY
HOSES (5). Thread the RISER TUBE (1) into base of the
VALVE BODY (2) and tighten fully.
• Slide the FLOOR MOUNTING FLANGE (3) onto the RISER
TUBE (4) with the flange. Thread RISER TUBE (4) into
the bottom of RISER TUBE (1) and fully tighten.
Note: Be careful not to scratch the faucet while
tightening the tube assembly.
2
5
1
4
3
FLANGE
2
INSTALL BATH SPOUT AND HANDLE
TO TUB FILLER
• Install SPOUT (1) into faucet body. Make sure
O-RING (2) is installed and not damaged.
• Hand tighten SPOUT NUT (3). Align and center the
SPOUT (1) with the center line of the faucet body.
With an adjustable wrench fully tighten the SPOUT
NUT (3).
Note: Be careful not to scratch faucet while
tightening SPOUT (1).
• Insert HANDLE (4) on CARTRIDGE STEM, tighten
SET SCREW (5) with HEX WRENCH (6) supplied.
• Install INDEX BUTTON (7) into HANDLE (4).
2
FAUCET BODY
- 2 -
1
3
CARTRIDGE STEM
4
5
6
7
M965140 REV. 2.2 (5/22)
Publicidad
