Publicidad
Idiomas disponibles
Idiomas disponibles
[] Basic Connection
Thissection describes h owto connect t heunit toan antenna,cablereceiver orsatellitebox.
Note:
• Besure your antenna or other device is connected properly before plugging in the power cord.
[Antenna
Cable Connection]
When connecting
the unit to an antenna
or cable TV signal (without
cable receiver/satellite
box)
Connect
the RF coaxial cable on your home outlet to the antenna
input jack of this unit.
e.g.)
VHF/UH_I_
antenna
II
rearofthisunit
t
RF coaxial
cable
ca ble TV
signal
_Once connections
are completed,
turn on the unit and begin initial setup.
Channel
scanning
is necessary for the unit to memorize
all available
channels in your area.
(Refer to"Initial
Setup"on
page 11.)
Note:
• If you have any question about the DTV's antenna, visit www.antennaweb.org for further information.
• Foryour safety and to avoid damage to device, please unplug the RFcoaxial cable from the antenna input jack before moving the unit.
• If you use an antenna to receiveanalog TV,it should also work for DTV reception. Outdoor or attic antennas will be more effective than set-
top versions.
• To easilyswitch your reception source between antenna and cable, install an antenna selector.
• If you connect to the cable system directly, contact the CATVinstaller.
[Connection
to Cable Receiver or Satellite Box]
Use an RCA component
video cable to connect
the component
video input jack of the unit to the component
video
output
jack of the cable receiver / satellite box.
If you connect
to the unit's component
video input jack, connect
RCA audio cable to the audio L/R jack of VIDE02.
e,g.)
rear of this unit
satellite
dish
RFcoaxial
(green)
(blue)
(red)
AUDIO
OUTq
COMPONENT VIDEO OUT
f
L
R
Fy
Pb/Ob
PriOr_
cable receiver / satellite
box
RCA audio cable
You can also connect
this unit to the cable receiver or satellite box other than the component
video output
jack
because they might
have different
output
jacks.
Required
cables and connecting
methods
of the cable receiver / satellite
box, or the availability
channel
for the clear
QAM may differ depending
on the cable/satellite
provider.
For more information,
please contact
your cable/satellite
provider.
EN
Publicidad
