Publicidad
Idiomas disponibles
Idiomas disponibles
6. Wiring. (cont.)
[PLEASE NOTE: Wall and/or handheld remote
control must be used for fan to operate. If you do
not wish to use the wall control, please proceed to
Section 7 to continue with fan installation.]
To install wall control, remove existing wall
switch. Wire one of the wall controls with wire
connectors provided as shown in diagram at right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT: Wall control will not function
unless battery is installed.
Since this fan comes with LED bulbs, the
dimmer switch (labeled DIM and ON) has been
pre-set to the "ON" position (DIM). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (ON).
Select a faceplate (almond or white) and press
firmly onto front of wall control. Attach wall
control to outlet box and secure with screws
from original wall switch. Attach wall plate
(included) to wall control using 2 screws
provided with the wall control.
7. Fan Assembly.
Remove motor housing from j-hook on
mounting plate. Lift motor housing to
mounting plate and carefully push wiring
and wire connectors into outlet box.
Align slotted holes on top rim of motor
housing with loosened screws in
mounting plate. Twist motor housing to
lock. Re-insert the 2 screws that were
previously removed (page 3, Section 4)
and then tighten all 4 screws to secure
motor housing.
Locate 4 tabs inside housing ring. Align
tabs in housing ring with 4 screws at top
of motor housing. The tabs must fit
snugly over the screwheads to ensure a
secure fit. NOTE: It is recommended to
push one tab on at a time instead of
doing all four at once.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
*
Reorient or relocate the receiving antenna.
*
Increase the separation between the equipment and receiver.
*
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
outlet box
green/
green/
green/
bare
bare
bare
ground
ground
ground
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
(wiring for wall control)
slotted hole
tab
page 5
wall control
-
1 1
-
2 2
green
DIM ON
black (OUT to fan)
12V battery
mounting plate
j-hook
housing ring
motor
housing
radio
radio
or television
dimmer
switch
face-
plate
wall plate
Publicidad
