Maintenance; Technical Service; Troubleshooting Chart; Corrective Action - Campbell Hausfeld RP3300 Manual De Instrucciones

Operating Instructions

Maintenance

Fuse RePlACeMent
Never replace a blown fuse with a fuse having a higher rating .
1) Unscrew end of plug counterclockwise to remove fuse .
2) If fuse is blown, replace with a new 15-amp fuse (5 mm x 20 mm, 250V) . Always
replace a blown fuse with the same size fuse .
3) Reassemble plug . Do not overtighten .

Technical Service

For information regarding the operation or repair of this product, please call
1-800-543-6400 .

Troubleshooting Chart

Symptom
Gauge is not on
Inflator will not start
Desired pressure unit
not shown
Inflator does not shut off 1. Faulty power connection
6
www.chpower.com
Possible Cause(s)
1. Vehicle's engine not running
2. Vehicle's fuse for power outlet is blown
3. Inflator's fuse for power plug is blown
1. Red power button not pressed
2. Pressure in tire may be greater than the
desired pressure setting
Desired pressure not selected
2. Item you are inflating has a hole or leaks
3. Inflator is not working properly
If problem can not be resolved, call 1-800-543-6400
15 amp
Fuse
Figure 5 - Fuse Replacement

Corrective Action

1. Turn on your vehicle
2. Replace fuse
3. Replace fuse (see above)
1. Press red power button
2. Release some pressure from tire or reset desired pres-
sure to a higher setting
Use a pin size object to change the desired pressure unit
(psi, kPa, or bar) while inflator is connected to a power
source. See page 3.
1. Disconnect power plug. Reconnect to power outlet.
2. Patch hole or leak
3. Call Customer Service at 1-800-543-6400