Publicidad
Idiomas disponibles
Idiomas disponibles
It is VERY IMPORTANT to test the system when first set up, and at regular
times thereafter. Test the units if you suspect they may have been damaged or have
not been used for a long time.
1. If two adults are present, have one take the Parent Units to different locations, trying
various volume settings, while the other speaks into the Nursery Unit.
2. If only one adult is available, place a ticking clock, radio, or other sound-producing
device near the Nursery Unit to test it.
3. When testing, keep the level of your child's sounds in mind, and adjust the volume
accordingly.
4. If there is sound interference, switch the Nursery Unit and the Parent Units to the other
channel setting.
To Listen To Baby
• Turn on Nursery Unit using the ON/OFF switch.
• Turn on Parent Unit using the Power/Volume wheel.
• Adjust the volume on the Parent Unit by turning the Power/Volume wheel.
• To activate Static Filter Technology, slide the "SF" switch to the ON
position on the Parent Unit.
• When SF is activated, a sound filter will eliminate noises below a certain
threshold. This allows you to filter out the white noise and static in the
room, allowing you to hear only the sound of your baby.
• If no sounds inside the room are louder than the threshold, no sound
will be transmitted at all through the speaker. This should not be con-
fused with the monitor not working.
• To test that your monitor is working while Static Filter Technology is
enabled, ask another adult to speak into the Nursery Unit.
• If only one adult is available, place a ticking clock, radio, or other
sound-producing device near the Nursery Unit to test it.
• To deactivate Static Filter Technology, slide the "SF" switch to the OFF
position on the Parent Unit.
• This will discontinue any sound filtering and allow you to hear all
sounds, including white noise, coming from the Nursery Unit.
All manuals and user guides at all-guides.com
Testing the System
Operation
Static Filter
5
Publicidad
