Publicidad
Idiomas disponibles
Idiomas disponibles
45" W x 18" D x 72" H 4-Shelf Steel Storage Rack
CMXMSAJ94994
IMPORTANT SAFETY INFORMATION
WARNING:
instructions, illustrations and specifications
provided with this storage rack. Failure to follow
all instructions listed below may result in personal
injury and/or property damage.
Work Area Safety
a ) Keep work area clean and dry.
b ) Use correct/recommended tools for the job.
c ) Never leave unattended tools plugged in
or running.
d ) Never force a part into place.
e ) Keep small parts away from children. Never
leave children unattended during assembly or
during use.
Personal Safety Warnings
Failure to heed these warnings may result in
personal injury and/or property damage.
a ) Wear appropriate safety apparel for the job you
are doing.
b ) Wear safety glasses/goggles.
c ) Never crawl, sit, stand, or climb on the rack
d ) Always use common sense – your personal
safety is your responsibility.
ANTI-TIP STRAP SAFETY WARNINGS
WARNING: Serious injury or death can occur
from the rack tipping over. To prevent this, the
rack must be secured to a wall, especially in
earthquake -prone areas, or where surfaces are
uneven, and where children and/or pets are present.
Different wall materials require different types
of fasteners. Use fasteners suitable for your
specific type of wall. If you are uncertain about
what type of fastener to use, then please contact
your local hardware store.
Weight Limit Safety Warnings
WARNING: Never exceed the following
weight limits:
a ) Maximum load for each shelf: Up to 600 lbs
(272.2 kg) when weight is evenly distributed.
b ) It is recommended that the heaviest load be placed
on the bottom shelf.
SAVE ALL WARNINGS
AND INSTRUCTIONS FOR
FUTURE REFERENCE
Read all safety warnings,
PRODUCT SPECIFICATIONS
RACK DiMEnsiOns
Width
Depth
Height
shElF CAPACiTiEs
Capacity Per Shelf
Total Rack Capacity
RACK WEighT
READ ALL INSTRUCTIONS
Vertical Pole Assembly (Fig. B)
nOTE: For ease of assembly, it is advised to place lower
shelves before assembling poles.
nOTE: The coupler should easily thread into either ends
of the pole. Ensure that both ends of the pole are secured
tightly to the coupler and there is no movement.
1. Install threaded coupler
vertical pole
3
.
2. Next, thread the bottom of the upper vertical pole
to the threaded coupler.
3. Press in the top cap
pole. (Fig B.)
4. Screw in the leveling foot
Turn leveling foot until it stops.
5. Repeat Steps 1 through 4 for each remaining pole.
5
Fig. B
4
3
6
45" (114.3 cm)
18" (45.7 cm)
72" (182.9 cm)
600 lbs (272.2 kg)
*when weight is
evenly distributed
2,400 lbs (1,088.6 kg)
*when weight is
evenly distributed
54.7 lbs (24.8 kg)
4
into the top of the lower
5
into the top of the assembled
6
to the bottom of the pole.
2
English
2
3
Publicidad
