Publicidad
Idiomas disponibles
Idiomas disponibles
4) The improper disposal of used batteries and accumulators is the cause
of environmental contamination. Please discard the batteries in
accordance with local regulations. Please do not dispose of the batteries
together with food waste. Protect the environment together!
5) After each use of the device, charge the battery to prolong its life.
Do not store the scooter's battery in rooms with temperatures exceeding 50
℃ or -20 ℃ (for example, do not leave the electric scooter's battery and
other batteries in cars in summer in the sun), do not leave the battery near
the fire. As a result of these actions the battery may deteriorate, overheat
and may even cause inflammation. If the scooter is not used in 30 days,
charge the battery and keep the device in a cool, dry place. Every 60 days
you need to charge the battery, otherwise there is a probability of failure,
which is not subject to warranty services. Avoid a full discharge of the
device, it will extend the life of the battery. When using the device at
normal room temperature, the battery will last longer distances and its
performance will be better, but if you use the scooter with temperatures
below 0 ℃, the vehicle performance and permeability decrease.
A-20 ℃, the distance covered is less than that of the scooter under normal
conditions. If the temperature increases, the distance traveled by the
vehicle will also increase. You can verify the remaining distance in the
application.
Note: a full-load scooter operates between 120 and 180 days of standby
time. The battery has an intelligent chip, which stores information about its
charge-discharge. If you do not charge the battery for a long time, it can
cause serious damage, making it impossible to recharge the device, again.
This type of damage is not included in the free warranty service. (Caution:
Do not disassemble the device with unauthorized personnel, as there is a
risk of electric shock, serious injury as a result of a short circuit.
15
Adjusting the brake disc
If the brake is too tight: use the M5 hex wrench and move the screws
counterclockwise of the brake disc tensioner pulley, shorten the length of
the tail brake cable slightly, then tighten the tensioner pulley. If you think
the brake is too loose, loosen the tension of the pulley, pull a brake cable to
slightly increase its tail length. Tighten the tension of the pulley.
Handlebar adjustment
Using the connecting tube to inflate the wheels
If the rear wheel of the electric scooter is deflated, connect the connecting
tube to the wheel nipple to inflate it. First, remove the cap from the pin,
then tighten the fitting and then begin to inflate the wheel.
16
Publicidad
