Contest VBAR-50DW Guia Del Usuario página 23

VBAR-DW - IP66 architectural projectors with 12/24 Dynamic white LEDs
6.7 - VRDM-Split splitter :
The VRDM-Split is a DMX RDM 1xIN 2x OUT IP66 splitter. It reboosts the incoming DMX signal on two RDM-compatible DMX outputs. It has a
Hybrid Power/DMX input on which the DMX signal will be extracted in order to be divided into two separate isolated and protected lines.
The Hybrid input supply will be disconnected and a new Power IN supply will be injected on the two Hybrid outputs.
architectural-lighting.eu
IN
CAUTION !
The sum of the powers
of the different lines
must not exceed the
power of the Power input
(3500W).
The power per line is
limited to the charac-
teristics of each of the
devices, see table in the
section on chaining of
projectors.
D+ D- GND
DMX-IN
L
N
Disconnect
Power
Hybrid
POWER+ DMX IN
Hybrid
Power + DMX OUT1
Distributed by HITMUSIC SAS
FRANCE
MADE IN CHINA
OUT
Contest Architectural Lighting
VRDM-Split
D+ D- GND D+ D- GND
DMX-OUT1 DMX-OUT2
L N L N L N
Power OUT2
Power OUT1 Power INPUT
16A (3500W max)
Power + DMX OUT2
VRDM-Split
Contest Architectural Lighting
VRDM-Split
D+ D- GND D+ D- GND D+ D- GND
DMX-IN DMX-OUT1 DMX-OUT2
L N L N L N L N
Disconnect Power Power OUT1 Power OUT2 Power INPUT
Power IN
IN
OUT1
OUT2
IN
OUT
The Hybrid Power+DMX IN input on the left is used to recover the
DMX signal which will be filtered, divided and protected.
The power supply will be disconnected from the circuit via the
Disconnect Power connector.
The Power IN input on the right is used to supply the splitter and to
re-inject the supply into the outputs.
Outputs OUT1 and OUT2 therefore have a reboosted DMX signal
and power supply to start new lines.
Note :
In this case, the VRDM-Split is used in a Hybrid 1 x IN, 2 x OUT
configuration.
It is possible to use the VRDM-Split simply by entering with a DMX
IN signal to 2 x DMX OUT and supplying the box with power IN
Power IN
only.
It is also possible to mix the two combinations for more flexibility.
Hybrid
English
IN
OUT
Page 23