Bell
note:
the bell can be mounted on either the right
or left side.
Fasten the bell so that the ratchet ring passes through
the intended opening. Remove the bell by pressing
the release lever and pulling the ratchet ring
out (fig.5, 6).
stick holder
Push the stick holder up and down
in the manner intended(fig.7).
setting the hand grip height
Warning!
• Make sure that the push handles are set at the same height in
order to maintain safe transport and use.
• the push handles must click audibly into the 7 holes <cLIcK>.
• turn the retaining screws only up to the red line.
note:
We recommend the hand grip height to be set at the same height as that of the wrists
when hanging down at arm's length when standing.
1. In order to set these at the correct height, release the push
handle retaining screws ,(fig.8).
2. Pull the push handles out to the required height and then
tighten the retaining screws. If the retaining screws are
not exactly parallel with the frame tubing after tightening,
press the locking button in and arrange the retaing
screws in the correct position (Fig.9).
38
fig. 7
fig. 5
fig. 8
fig. 6
fig. 9