Checking The Codes; Using Learning - Universal Electronics ATLAS DVR/PVR 5-DEVICE Guia Del Usuario

6. Press SETUP once to lock in the code. The TV
key will blink twice.
7. To search for the codes of your other devices,
repeat steps 1 through 5, but substitute the
appropriate key (e.g., AUX, DVD, AUD, or CBL)
for the device you are searching for.

CHECKING THE CODES

If you have set up the Atlas DVR/PVR 5-Device
Universal Remote Control with Learning by searching
for your device code (on the previous page), you may
need to find out which four-digit code is operating your
equipment.
For example, to find out which code is operating your TV:
On the remote control, press TV once; it will
1.
blink once. Then press and hold SETUP until
the TV key blinks twice.
2. Enter 9 9 0. The TV key will blink twice.
3. To view the code for the first digit, press 1
once. Count the number of times the TV key
blinks (e.g., 3 blinks = 3) and write down the
number in the leftmost TV Code box on
page 10.
NOTE: If a code digit is 0, the selected mode key will
not blink.
4. Repeat step 3 three more times for the
remaining digits. Use 2 for the second digit, 3
for the third digit, and 4 for the fourth digit.
Finish writing down the code in the TV Code
boxes on page 10.
5. To check for other device codes, repeat steps 1
through 4, but substitute the appropriate key
(e.g., AUX, DVD, AUD, or CBL) for the device
you are checking. Write down the codes in the
appropriate boxes on page 10.

USING LEARNING

The Atlas DVR/PVR 5-Device Universal Remote Control
with Learning includes a Learning feature so you can
add functions that are unique to your home
entertainment devices (e.g.,VCR Tracking Up or Down).
However, there are some considerations.
www.urcsupport.com
12