Onkyo DMI-40.4 Manual De Instrucciones página 27

E41_DMI-40.4_En_120711.book 27 ページ ２０１２年７月１１日 水曜日 午後５時４１分
Restoring the Default Settings
You can restore the DMI-40.4 to default settings.
Perform this when the needs to restore the DMI-
40.4's name, volume value and network settings
arise.
Turn the power of DS-A5 on.
1
Press the Repeat button on the remote
2
controller for 10 seconds.
LED blinks in blue and green alternately, and the
DMI-40.4 goes into default setting mode.
Press the Mute button on the remote
3
controller for two seconds.
The DMI-40.4 goes into standby status and
LED turns off a light. The setting is restored to
the default settings.
Note
• Unless Mute button is pressed within 30
seconds after LED blinks in blue and green
alternately, the default setting mode
terminates.
Troubleshooting
No Sound or Video
• Make sure your iPod/iPhone/iPad is connected
properly.
• If there's no video, make sure your
iPod/iPhone/iPad supports TV out.
• Make sure your iPod/iPhone/iPad is playing.
• Make sure your amp or AV receiver is turned on,
the input to which the DMI-40.4 is connected is
selected as the input source, and the volume
control is not set to minimum.
• Make sure all plugs are pushed in all the way.
• Make sure the DMI-40.4 is connected to the correct
input jacks on your amp or AV receiver. If there's no
video, check your video connections. Do not
connect the DMI-40.4 to any jacks on your amp or
AV receiver labeled OUT.
• Make sure the AC adapter is properly connected to
the DMI-40.4 and a suitable wall outlet.
• Try resetting your iPod/iPhone/iPad.
27