Using The Marking/Etching Wand (Optional); A) Marking Kits; B) Selecting The Proper Mode; C) Surfox Testing Devices - Walter SURFOX 204 Manual De Usuario

8

Using the marking/etching wand (optional)

Using the marking/etching wand (optional)

A) Marking kits

Standard kit (54-B 080) includes:
• 1 marking/etching wand with
graphite insert
• 35 mm X 10 mm
and connecting cable
• 20 marking pads
• 5 O-Rings
• 1 SURFOX-M, 100 ml
solution
• 1 SURFOX-E, 100 ml
solution

B) Selecting the proper mode

Turn the selector knob to the marking/etching wand icon.
Use the marking/etching wand to permanently mark or etch
your company name, logo, part number or other desired
information onto the surface of stainless steel, using perma-
nent or disposable stencils. Plug the marking/etching wand
into the accessory outlet on the front panel.

C) SURFOX testing devices

Stainless steel Passivation Testing Device
(54-T 010)
reduced near welds as a result of the heating cycle. Visu-
ally, this can be seen as a darkened zone next to the weld.
When electro-chemical cleaning is performed on the weld,
corrosion risk is reduced but the treated zone still has to be
passivated for 24-48 hours before the corrosion protection
is fully restored.
12
To monitor the state of corro-
sion protection and to ensure
proper passivation of the
workpiece.
Corrosion resistance of
stainless steel is significantly
PRO kit (54-B 081) includes:
• 1 marking/etching wand with
graphite insert
• 35 mm X 10 mm
and connecting cable
• 20 marking pads
• 5 O-Rings
• 1 SURFOX-M, 100 ml solution
• SURFOX solution, 100 ml
• 1 Stencil printer and software
• 1 Stencil paper roll 100 mm (W) X 20 m (L)
Marking/etching
wand
Stainless steel Grade Identification Testing
Device (54-T 001)
Informs you on the type of stain-
less steel you are really working
with.
Because it is visually impossible
to differentiate 200, 300 and 400
grade stainless steel, the test-
ing device instantly identifies the
grade of stainless steel.
TECHNICAL BULLETINS AVAILABLE ON OUR WEB SITE.