Audibax RF10 Manual De Usuario página 2

RF10
RF10 STUDIO MIC SCREEN / RF10 PANTALLA PARA MICROFÓNO DE ESTUDIO
A. Screen
B. Sliding Beam
C. Locking Screws
D. Shockmount Adapter
A. Pantalla
B. Viga deslizante
C. Tornillos de bloqueo
D. Adaptador de suspensión
1
FIG. 1
INSTALLATION:
Please fasten the screw C first, then place
this equipment on the top of the mic stand,
please make sure the mic stand top goes
through the hole of the sliding beam B, then
fasten the Shockmount adapter D. Make
sure it is in a stable status. The installation is
finished (See FIG.1)
INSTALACIÓN:
Apriete el tornillo C primero, luego coloque
este equipo en la parte superior del soporte
del micrófono, asegúrese de que la parte
superior del soporte del micrófono pase por
el orificio de la viga deslizante B, luego
ajuste el adaptador Shockmount D.
Asegúrese de que esté en una posición
estable estado. La instalación está
terminada (Ver FIG.1)
FIG. 2
APPLICATION:
1. Loosen the both screws C on the back of the screen A , you can adjust the screen A in
vertical position freely.ln order that the microphone can be located in an appropriate
position.(See FIG2), then fix the both screws C.
2. Loosen the Shockmount adapter D , slide the Sliding beam B along the groove
in horizontal direction.Once the mic is located in the right position,fix the Shockmount
adapter.
3. After above adjustment,you can start the recording.lf you are not satisfactory
with the position,you can adjust it again as per above procedures.ln order that you can get
a perfect recording effect.
USER´S MANUAL
MANUAL DE USUARIO
FIG. 3
2