Kenmore 30 Manual Del Usuario página 12

Care and Cleaning
(continued)
Drawer Removal
Drawers will stop before
coming all the way out of the
refrigerator to help prevent
contents from spilling onto
the floor Drawers can easily
be removed by tilting up
slightly and pulling past
"stop" location
On some models you may
need to remove the door
bins from the fresh food door
before removing the drawers
'_'_ ,_. Drawer
Jthe drawers _--_
l make sure you \_
Jslide them fl
I through the "
{ drawer guides
Ion the right side
If the door prevents you from taking out the drawers, the
refrigerator will need to be rolled forward until the door
opens enough to slide the drawers out. In some cases
when you roll the refrigerator out you will need to move
the refrigerator to the left as you roll it out
Under Refrigerator
For most efficient operation,
you need to keep the area
under the refrigerator clean
Remove the base grille and
either sweep away or
vacuum up dust that is
readily accessible on the
condenser coils
To remove the base grille,
open both doors, grasp the
Clean the condenser ceils
at least once a year
bottom of the grille and pull it out
To replace the base grille,
line up the clips on the back
of the grille with the openings
in the baseplate and push the
grille forward until it snaps
into place
Behind Refrigerator
Take care moving your refrigerator away from the wall All
types of floor coverings can be damaged, particularly
cushioned coverings and those with embossed surfaces Pull
the refrigerator straight out and return it to position by
pushing it straight in Moving refrigerator in a side direction
may damage floor covering or refrigerator
When pushing the refrigerator back, make sure you don't
roll over the power cord or icemaker supply line
]2
Light Bulb Replacement
Unplug refrigerator before changing a light bulb.
Fresh Food Compartment-Upper Light
1. Pull off temperature control knobs
2. Pull the bottom of the light shield down and forward,
then rotate the top up and off
After replacing with same size bulb, reinstall light shield.
Fresh Food Compartment--Lower Ught (on some models}
This light is located behind the top drawer or right above
the top drawer (depending on your model}
1. Unplug the refrigerator
2. If the light is behind the top drawer you will need to
remove the drawer and the shelf above it To remove the
drawer see the Drawer Removal section in Care and
Cleaning
- To remove the shelf first
remove any food on the shelf
Then tilt the shelf up at the
front and lift it up and out
of the tracks
3. Grasp the bottom of
the light shield and pull it
forward and up
4. After replacing with the same size bulb, replace the shield.
If you cannot locate the correct bulb, see your dealer
5. If the light was behind the top drawer, you will need to
replace the drawer and the shelf above it
" To replace the shelf, raise the shelf front slightly and
place the top hooks in the lowest large track slots Then
lower the front of the shelf until it is level
6. Plug the refrigerator back in
Freezer Compartment
1. Remove shelf lust below
light panel (Shelf will be
easier to remove if it is
emptied first )
2. Pull plastic light panel toward you (It will bend to free
tabs from grooves )
3. After replacing with same size bulb, reinstall panel
and shelf