Publicidad
Idiomas disponibles
Idiomas disponibles
Continuous distance measurement:
Area measurement:
Volume measurement:
36
MED50R.indd 36
Measurements & calculations
Simple distance measurement:
Press the button
is projected on the surface at a distance that you want
to know its distance. Once the laser is projected on this
surface, press the button
measurement which will appear on the main screen.
Press the button
distance measurement mode, in this function you
can see the maximum and minimum distance on the
auxiliary display. To exit this function you just have to
press
or
Press the button
the upper left and one of its lines is blinking. To measure
the area of a surface you must take 2 measures: lenght
and height. First measure the base of the area by
pressing the button
measurement on the display. After that, position the laser
to take the height and press the button
second measurement will appear on the display and the
calculation of the area will appear big at the bottom.
Press the button
in the upper left corner and one of its lines is blinking.
To measure the volume, press the button
measure the base of the surface to be calculated, then
press it again to measure the height and finally the depth.
In this way the main screen will show the area calculated
to activate the laser, once the laser
again for a simple distance
for 3 seconds to enter the continuous
.
until the figure
and the meter will mark the first
twice until the figure
is displayed in
again. The
is displayed
once to
28/4/22 12:17
Publicidad
