GE WSLP1500 Manual Del Propietario E Instalación página 9

I
I
stallation
structi
We hers
WSLP1500 and WSLS1500
If you have any questions, coil 800.GE.CARES(800.432.2737)
or visit our Website
at:ge.com
In Canada, coil 1.800.561.3344
or
visitGEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completelg and carefullg.
.iMPORTANT - Savethese instructions
for local inspector's use.
" IMPORTANT
- Observe all governing
codes and ordinances.
, Note to Installer
- Be sure to leave these
instructions with the Consumer.
, Note to Consumer - Keep
these instructions
for future reference.
Skill level - Installation of this appliance requires
basic mechanical skills.
, Completion time - 1 hour
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the Warranty.
,
Note
- This appliance must be properly grounded,
and electrical service to the washer must conform
with local codes and ordinances and the latest
edition of the National Electrical Code, ANSI/NFPA 70.
WASHER LOCATION
Washer must be installed on firm flooring to minimize
vibration during spin cycles. Concrete flooring is best,
but wood base is sufficient providing floor support
meets FHA standards. Washer should not be installed
on rugs or exposed to the weather.
Install or store where it will not be exposed to
temperatures below freezing or exposed to the weather.
ELECTRICAL
This appliance must be supplied with the voltage and
frequency indicated on the rating plate (located on
the back of the washer) and connected to an individual,
properly grounded branch circuit, protected by a 15- or
20-amp circuit breaker or time-delay fuse.
If the washer is plugged into the dryer's 11S-volt outlet,
then the dryer needs to be on a dedicated circuit.
PLUMBING
, WATERPRESSURE--Mustbe 10 p.s.i, minimum to 150
p.s.i, maximum dgnamic pressure measured at faucet.
WATERTEMPERATURE--Household water
heater should be set to deliver water at 120 ° to 150°F
(50° to 66°C) IN THE WASHERwhen HOTwash is
selected.
SHUT-OFFVALVES--Both hot and cold shut-off valves
(faucets) should be supplied.
DRAIN--Water mag be drained into a standpipe or set
tub. The discharge height MUST NOT BE LESSTHAN
30" nor more than 8' above the base of the washer.
The standpipe must be 1V2"minimum inside diameter
and must be open to the atmosphere.
RACK INSTALLATION
Ensure washer is centered between the rack sides.
PARTS SUPPLIED
Water Hoses(2)
RubberWashers(4)
DrainHose
TOOLS
REQUIRED
Pliers