Range Lock-Out - GE P2S975 Manual Del Propietário

Using the clock, timer and range lock-out.
Make sure the clock is set to the
correct time of day.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Timer
Touch the KITCHEN TIMER
ON/OFF pad.
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a
mistake touch the KITCHEN TIMER
ON/OFF pad and begin again.
Touch the START pad.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by
touching the KITCHEN TIMER ON/OFF pad,
then touch the number pads until the
time you want appears in the display.
To Cancel the Timer
Touch the KITCHEN TIMER ON/OFF
pad twice.

Range Lock-Out

(on some models)
Your control will allow you to lock out the surface
burners, oven burners and control panel so they
cannot be activated.
To lock/unlock the controls:
Turn all surface burners off.
Touch and hold the RANGE
LOCK-OUT pad for 3 seconds until
the display shows LOC ON.
To unlock the control, touch and
hold the RANGE LOCK-OUT pad for
3 seconds until the display shows
LOC OFF.
GEAppliances.com
Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF pad is
touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the KITCHEN TIMER ON/OFF pad
and then touching the number pads to
enter the new time you want.
When this feature is on and the touch
pads are touched, the control will beep
and the display will show LOC ON.
■
The control lock-out mode affects all controls.
No controls will work when this feature is
activated.
■
The adjustment will be retained in memory
after a power failure.
13