Velleman IREXT Manual Del Usuario página 5

5. Installation/Operation
Application 1: Use with IR bender only
• Insert the plug of the IR probes [F] into the IR probes output
connection [B] at the back of the IR bender [A].
• Install the IR bender flat on a horizontal surface within sight and
reach of your remote control (± 6m in ideal circumstances).
• Lead the IR probes inside the cabinet and to the A/V equipment
in such way that a LED can be stuck onto the IR eye of each A/V
apparatus. Test the position of each LED first before sticking as
this should be done carefully and precisely.
• Insert the plug of the PSU into the PSU input connection [D] at
the back of the IR bender. Only use the supplied PSU. Connect
the PSU to the mains.
• Use your remote control and point towards the IR bender within
an angle of ± 15° in all directions.
01.07.2009
IREXT
5
Rev. 02
©Velleman nv