Publicidad
EN - Camera Mounting
1.
Place the provided Mounting Template onto the desired location. Ensure an outlet is nearby, and keep in mind the
cable length.
2.
Using a drill, drill through all 3 mounting screw holes on the template.
Note:
Drill a hole through the center of the template for your camera's cable if you plan to run it through the
mounting surface. If you are running the cable along a wall/ceiling, make sure to pass the cable through the cable
notch.
3.
Using a Phillips-head screwdriver and the provided Mounting Screws, secure the Mounting Bracket to the surface.
Optional:
If you are mounting your camera into drywall, use the provided anchors.
4.
Connect your camera's cable to the Power Adapter and plug into a nearby outlet.
5.
(Optional)
Use the provided Cable Clips and Screws to neatly secure your camera's cable to the wall.
6.
Adjust the angle of your camera:
•
Loosen the Camera Adjustment Screw to rotate your camera downwards and sideways, then tighten to
secure it in place.
•
Loosen the Mounting Bracket Adjustment Screw to rotate your camera and bracket clockwise or counter-
clockwise around the base, then tighten to secure it in place.
•
Tip:
For a sideways orientation of your camera you must rotate the mounting bracket by 90°, rotate the
camera by 90°, and then point your camera to the desired side.
7.
Remove the vinyl film from the camera lens once your installation is complete.
7
Mounting Screw
Vis de montage
Tornillos de montaje
Drywall Anchor
Chevilles pour cloison sèche
Taquetes para yeso
Mounting Template
Gabarit de montage
Plantilla de montaje
Mounting Surface
Surface de montage
Superficie de montaje
Cable Notch
Encoche du câble
Ranura para cables
8
Publicidad
