Publicidad
Idiomas disponibles
Idiomas disponibles
9. Be sure the trailing edge of blade (op-
positesharp edge) is up towardthe
engineas shown.
10.Installthe bladebolt with the lock
washer and hardenedwasher into
bladeadapter and crankshaft.
11.Use blockof wood between bladeand
lawn mowerhousingand tighten the
blade bolt, turning clockwise.
° The recommendedtighteningtorque is
35-40 ft. Ibs.
IMPORTANT:Blade bolt is heattreated.
If bolt needs replacing,replaceonly with
approvedbolt shown in the RepairParts
section of this manual.
12.Returnmowerto upright position.
13.Reattachdrive cable spring to the idler
arm assembly,then reattachdrive
cable to anchor.
14.Reattachdrive cover with screws previ-
ously removed.
15.Connectspark plug wire to spark plug.
TO
ADJUST HANDLE
The handle on your lawn mower has three
(3) height positions - adjust to the height
that suits you.
• Squeeze the bottom ends of lower
handle towards each other until the pin
in handle can be inserted into one of the
three height adjustment holes.
SQL
pin
Low
Handle
bracket
ENGINE
ENGINE
SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that engine is running too fast or
too slow, take your mower to a Sears or
other qualified service center for repair
and adjustment.
CARBURETOR
Your carburetor is not adjustable.
If your
engine does not operate properly due to
suspected carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set
for proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.
Immediately prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN
MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
,
15
1. Clean entire lawn mower (See
"CLEANING"
in the Maintenance
sec-
tion of this manual).
2. Lubricate as shown in the Maintenance
section of this manual.
3. Be sure that all nuts, bolts, screws, and
pins are securely fastened.
Inspect
moving parts for damage, breakage
and wear. Replace if necessary.
Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
Publicidad
