Johnson Eco Vacuum Instrucciones De Funcionamiento página 14

A. Lower body-half
C. ON/OFF button
E. Side filter holder grills
G. Motor filter
M.HEPA filter
X. Body-half (B) tooth
O. Nozzle it concentrates the vacuuming
process. Useful to clean angles
and recesses.
Q. Multifunction nozzle, with pedal
selector for floors, carpets and
wall-to-wall carpeting
• Remove the parts of the electric broom from the packaging.
1. Check that the side filters and motor filter are present on the upper body-half (B)
• Check that the HEPA filter (M) is present on the lower body-half (A).
• Contact an authorised Service Centre if only one of these filters is missing.
Do not start the electric broom if one of these filters is missing.
2. Join the two body halves (A and B) by inserting the tooth (X) of the body-half (B) in
to the slot (Y) of the other body-half (A). Block into place with the front closure (K).
3. Attach the accessory most suitable to the work that needs to be carried out at the
end of the appliance.
4. Turn the hook (D) located on the back of the handle downwards, completely unwind
the cord and insert the plug into a compatible power outlet.
• Now, turn on the appliance via the ON button to vacuum solid substances.
Do not vacuum liquids or other harmful materials!
• After each use, empty the dirt collected in the body half (A) before replacing the ap-
pliance: this operation must be carried out with the appliance OFF and the plug di-
sconnected from the power outlet.
Raise the front closure (K) to separate the two halves (A and B).
5. Remove the HEPA filter (M) from the body half (A).
Turn the body half (A) upside down to empty the dirt collected and clean the outside
and inside.
Accurately reassemble the appliance before storing it away.
• If the operating time reaches 15 minutes, turn off the appliance and let the motor
rest for at least 5 minutes before restarting it.
• Periodically clean all the filters of the appliance and if damaged, replace. This ope-
ration must be carried out with the appliance OFF and disconnected from the electrical
network as explained below.
6. Extract the filter (G) from the grill (H).
Wash it with running water and dry.
Replace it.
Never operate the appliance without this filter!
PARTS
B. Upper body-half
D. Filter door hook
F. Side filters
H. Motor filter stopping grill
K. Front closure
Y. Slot for X
P. Multi-use nozzle to clean walls,
INSTRUCTIONS FOR USE
CLEANING the motor filter (G)
14
sofas, etc.