Wilfa Haze HU-400BCA Manual De Instrucciones página 19

Control panel Hands are too wet
does not work. when operating control
panel.
Humidifier has
malfunctioned.
White dust Water being used has
appears around a high mineral content.
the humidifier.
Humidifier was not
properly cleaned after
last use.
Mist is coming Water tank is not
out from the positioned correctly.
base.
Mist fog coming There are apertures
out from around between the nozzle
nozzle. and water tank.
The warm mist The humidifier is in
function does not warm-up phase.
produce warm
The mist is too fine to
mist.
feel the warmth.
The room temperature
is too cold, and the
mist may cool down
too quickly.
Display show Too much water in
error code EF. water basin.
Display show The water detector
error code E0. PCB and the power
PCB disconnect.
HAZE · HU-400BCA
Keep hands dry while
operating the control panel.
Contact Customer Support.
Use distilled water with the
humidifier. If distilled water is
not available, use purified or
filtered water.
Clean humidifier.
Turn off and unplug the
humidifier, then align the water
tank cover with its respective
opening in the inner chamber.
Reposition the cover and
check if the nozzle is well
plugged in the cover.
Wait a few minutes till the end
of the phase.
Increase the speed level.
Increase the speed level and
heat the room up.
Remove water tank and empty
water from the base.
Check and clean particles in
water outlet of water tank that
led to leakage. If no leaks,
replace into base.
Contact Customer Support.
17
EN