Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION STEPS
1. Unmount the tank from the base, unscrew the water tank cover and fill the
tank with water, screw the water tank cover back, make sure it sits tightly.
Replace the water tank on the base.
2. Check that the mist outlet nozzle is correctly mounted on the water tank.
3. Plug in the power; turn the knob clock wise to start the machine. Adjust
preferred mist output from minimum to maximum by turning the knob
clockwise. To decrease the output or turn off the machine please turn the
knob counter clockwise.
4. When the water level is too low the indicating light turns red and the machine
will stop work. Refill the tank and turn on the machine to continue operate.
5. The machine will stop work if the water tank is removed during operation.
6. The machine will resume operation when the water tank is replaced correctly.
CLEANING & MAINTENANCE
Before cleaning, turn the functional knob anti clockwise until it points to "OFF"
and disconnect the plug from the outlet.
WATER TANK INSIDE
Clean water tank inside and water sink twice per week at least when using the
on a daily basis. Water residuals may form along the tank's inside and can be
removed with soft dish brush. A soft cloth can also be used to wipe the insides of
the water tank. Don't put acid, alkalescency, bleacher detergent into water tank
to avoid damage.
WATER SINK INSIDE
The water quality in some regions can be rich of calcium (hard water). This can re-
sult in increased calcium deposits inside water tank or transducer. Users in areas
with high content a minerals should perform maintenance as often as needed.
• Add cleaning agent on the transducer surface (The amount of detergent is
directly dependent on the amount of calcium deposits).
• Fill water into the space that is located under the water tank placement (water
sink). Let the machine rest for 10-15 min.
• Then gently brush the transducer area free of calcium deposits. Clean the
entire sink area free of detergent and mineral deposits by using a dish brush.
• Rinse with fresh water and repeat at least two times. Don't use acid detergents
to wash the water sink inside to avoid damage on the transducer.
HUMIDIFIER · HU-35W, HU3-35W
9
EN
EN
Publicidad
