Audiomusic Systems SIX EYES 12 MKII Manual Del Usuario página 5

USE AND INSTALLATION
To start working with the device, first connect the unit to the mains.
The device will check for a few seconds to verify its correct status.
To connect several units together you must connect them with a 3 pin DMX cable, you must take into
account that to avoid possible problems you must terminate the line with a 120 Ohm 1/4W load
between pin 2 and 3 of the connector.
The unit can work in different operating modes. Through the menu you can select each of them and
configure the device according to the required mode.
4