Publicidad
Idiomas disponibles
Idiomas disponibles
Technical data
Operating data
Flow Rate
Water Pressure (recommended)
Water Pressure (max.)
Hot Water Temperature (recommended)
Hole Size For Faucet
Certifies this faucet complies with ASME A112.18.1 / CSA B125.1, NSF/ANSI/CAN 61-2021:
Q<1, NSF 372.
Installation instructions
Before you begin
For best results, Franke recommends
this faucet be installed by a licensed,
professional plumber. The installer should
read the instructions and familiarize
themselves with how the faucet
should be installed before attempting
installation. Make certain to observe all
local plumbing and building codes during
the installation.
Tools Needed:
1. Phillips screwdriver
2. Level
3. Thread sealant
4. Drill
Value
2.2 GPM at 60 PSI
30-85 PSI
2-6 bar
115 PSI
8 bar
158°F
70°C
1 3/8"
35 mm
Installation steps
1. Remove all contents from the package
and check for completeness.
2. Turn off water supply.
3. Remove faucet and hardware from its
protective packaging - faucet comes
assembled.
4. Provide ½" G (BSP) male nipple for
pot filler water supply at the desired
location.
Note: The faucet is intended for use
with cold water only!
5. It is recommended to install studs (C)
around the cold water supply nipple (D)
to support the mounting flange of the
faucet. The water supply nipple should
protrude between 13 mm (½") and
16 mm (5/8") (B) from the finished wall
surface (A) (fig. 2A).
5
EN
200-600 kPa
800 kPa
Publicidad
