Publicidad
Idiomas disponibles
Idiomas disponibles
STARTA CLEANRINSECYCLE
To manually
start a Clean Rinse cycle, press and hold the CLEAN button
for a few seconds, until "RECHARGE
NOW"
flashes in the display.
This
Clean Rinse cycle takes 3 minutes (unless the factory
settings for backwash
and fast rinse times have been changed,
as shown below).
SET CLEAN
RINSE START TIME
By default
the Central
Water
Whole
Home Filtration
System will Clean
Rinse at 1:00 a.m.
The system will not filter water
during
the Clean Rinse
cycle.
It is recommended
that the Clean
Rinse start time be set for when
water
is not likely to be used in the household.
NOTE:
If you also have a water
softener, set the Central
Water
System's
Clean Rinse time for either one hour before
or two hours after the
water
softener's
scheduled
regeneration
time.
To change
the Clean Rinse start time:
1. Press the ENTER button
a few times until "SET RECHARGE TIME" is
shown in the display.
2. Press the f
UP or V
DOWN
buttons
to set the Clean Rinse time in 1
hour increments.
Be sure AM or PM is correct.
3. When
the desired
Clean Rinse time is displayed,
press the ENTER button
a few times, until the time appears
in the display,
but is not flashing.
RECHARGE
NOW
Figure
14
RECHARGE
TIME
I.Ft I-I
I'UU
AM
Figure
15
SET LENGTH
OF CLEAN
RINSE
By default
the Central
Water
Whole
Home Filtration
System's Clean Rinse
cycle will consist of a 2 minute backwash
followed
by a 1 minute fast rinse.
This should be sufficient
for most applications.
Increasing
the length of Clean Rinse time will increase
the amount of water
flushed to drain during
each Clean Rinse cycle.
Increasing
the length of
Clean Rinse should only be done in cases of very high amounts of sedi-
ment, or other water
issues.
To change
the length of the backwash
or fast rinse parts of the Clean
Rinse cycle:
1. Press and hold the ENTER button
for a few seconds, until the "000--"
screen appears,
as shown at right.
2. Press the ENTER button once, so "SET TIME bA" appears
in the display.
3. Press the f
UP or V
DOWN
buttons
to set the length of backwash
in
minutes.
4. Press the
TIME Fr"
5. Press the
minutes.
.
ENTER button when the desired
backwash
time is shown.
"SET
appears
in the display.
f
UP or V
DOWN
buttons to set the length of fast rinse in
Press the ENTER button when the desired
fast rinse time is shown.
The
display
will change
to the time of day.
FIFI Fi ____
UUU
TIME
LO
I II!
m
SET
TIME
Fr'-
I
Figure 16
Questions?
Call The I<enmore Water
Line 1-800-426-9345
or visit KenmoreWater.com
14
Publicidad
