Descargar Imprimir esta página

Hitachi RPK-1.0FSNH2M Manual De Instalación Y Funcionamiento página 21

Ocultar thumbs Ver también para RPK-1.0FSNH2M:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 23
6.2. ALARM CODE INDICATION
ƒ
"RUN" (red lamp) blinks (0.5 second ON / 0.5 second
ƒ
"TIMER"(green lamp) and "FILTER / DEFROST"
("Yellow Lamp") as shown below.
"TIMER"(green lamp): The blinking is shown at the tens.
"FILTER / DEFROST" (Yellow lamp): The blinking is
6.3. IDENTIFYING OF INDOOR UNITS INSTALLED SIDE BY SIDE
-
LH3A "Identified" Indoor Unit.
"Identified" Wireless
Remote Control Switch"
Indoor unit A
(0.8-4.0) HP
NOTE:
When the batteries of wireless remote control switch are Replaced, the setting with wireless remote control switch is
canceled.
After replacing the batteries, set the point 6.3
"Identified Indoor Unit".
"Identified" Wireless
Remote Control Switch"
Indoor unit B
(0.8-4.0) HP
"FILTER/DEFROST" (Yellow Lamp)
"TIMER" (Green Lamp)
"TIMER" (green lamp) blinks 3 times (0.5 second
"FILTER/DEFROST" (yellow lamp) blinks 5 times (0.5
6.3.1. WIRELESS REMOTE CONTROL
IDENTIFYING SETTING
Remote Control B
Press the "ON TIME" Switch and the
"OFF TIME" switch of the wireless remote control sw
simultaneously for more than 3 seconds. The "' ' "
Remote Control A (Cancellation of Identifying
Setting).
Press the "ON TIME" Switch and the
"OFF TIME" switch of the wireless remote control switch
6
3 seconds. The ""

Publicidad

loading