Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING! or CAUTION! or REMEMBER! Applicable to the given situation.
(general warning sign)
ATTENTION! Electric shock warning!
PLEASE NOTE! Drawings in this manual are for illustration purposes only and in some details
may differ from the actual product.
2. Usage safety
ATTENTION!
The terms "device" or "product" are used in the warnings and instructions to refer to:
Mono Solar Module with Pure Sine Wave Inverter
2.1.
Electrical safety
a) The plug must fit the socket. Do not modify the plug in any way. Using original plugs and matching
sockets reduces the risk of electric shock.
b) Avoid touching earthed elements such as pipes, heaters, boilers and refrigerators. There is an increased
risk of electric shock if the earthed device is exposed to rain, comes into direct contact with a wet surface
or is operating in a damp environment. Water getting into the device increases the risk of damage to
the device and of electric shock.
c) Do not touch the device with wet or damp hands.
d) Use the cable only for its designated use. Never use it to carry the device or to pull the plug out of a
socket. Keep the cable away from heat sources, oil, sharp edges or moving parts. Damaged or tangled
cables increase the risk of electric shock.
e) If working with the device outdoors, make sure to use an extension cord suitable for outdoor use. Using
an extension cord suitable for outdoor use reduces the risk of electric shock.
f)
If using the device in a damp environment cannot be avoided, a residual current device (RCD) should be
applied. The use of an RCD reduces the risk of electric shock.
g) Do not use the device if the power cord is damaged or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or the manufacturer's service centre.
h) To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do not use
the device on wet surfaces.
i)
Prevent the device from getting wet. Risk of electric shock!
2.2.
Safety in the workplace
a) Make sure the workplace is clean and well lit. A messy or poorly lit workplace may lead to accidents. Try
to think ahead, observe what is going on and use common sense when working with the device.
b) If you are unsure about whether the product is operating correctly or if you find damage, please contact
the manufacturer's service centre.
c) Only the manufacturer's service centre may make repairs to the product. Do not attempt to make
repairs yourself!
d) In case of fire, use a powder or carbon dioxide (CO2) fire extinguisher (one intended for use on live
electrical devices) to put it out.
e) Children or unauthorised persons are forbidden to enter a work station. A distraction may result in loss
of control over the device.
f)
Use the device in a well-ventilated space.
g) Please keep this manual available for future reference. If this device is passed on to a third party, the
manual must be passed on with it.
h) Keep packaging elements and small assembly parts in a place not available to children.
Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in serious injury or even death.
Publicidad
