Publicidad
Idiomas disponibles
Idiomas disponibles
zt
_
41_WARNING:
Avoid any contact
with the muffleE A hot muffler can
cause serious
burns,
Starting Position
Choke Lever
Muffler
STARTING
A NEW
ENGINE
NOTE:
Add oil and fuel as instructed
in this manual prior to attempting
to
start engine (see ADD OIL and ADD
GASOLINE sections).
1. Set unit on a flat surface.
2. Slowly press the primer bulb 15
times.
3. Move red choke lever to FULL
CHOKE position.
4.
Squeeze the throttle trigger fully and
hold through all remainmg steps.
5.
Pull starter rope handle sharply until
engine runs.
6. Once the engine starts, allow it to
run a maximum
of 10 seconds at
FULL CHOKE. Then, slowly move
the red choke lever to the HALF
CHOKE position.
7. Allow the unit to run a minimum
of
20 more seconds
at HALF CHOKE
tcolder temperatures
may require
onger warm-up
periods before
the engine will accept a load and
accelerate
properly).
8. Move red choke lever to OFF
CHOKE position and allow the unit to
run a minimum of 20 more seconds
at OFF CHOKE. Release _qe _hrotUe
tdgger.
STARTING
ENGINE
NOTE:
Check oil level before starting.
Oil level should
be at the FULL mark
on the dipstick.
If not, add oil (see
ADD OIL section).
1. Set unit on a flat surface.
2. Slowly press the pdmer bulb 8
times.
3. Move red choke lever to FULL
CHOKE position.
4. Squeeze the throttle trigger fully and
hold through all remainmg steps.
5.
Pull starter rope handle sharply until
engine runs.
6. Once the engine starts, allow it to
run a maximum
of 10 seconds
at
FULL CHOKE. Then, slowly move
the red choke lever to the HALF
CHOKE position.
7. Allow the unit to run a minimum
of
20 more seconds
at HALF CHOKE
(colder temperatures
may require
longer warm-up
periods before
the engine will accept a load and
accelerate
properly).
8. Move red choke lever to OFF
CHOKE position and allow the unit to
run a minimum of 20 more seconds
at OFF CHOKE. Release the _hrotSe
tdgger.
RESTARTING
A WARM ENGINE
Follow steps listed in the STARTING
ENGINE section without squeezing
throttle trigger.
If the unit will not start, refer to the
TROUBLESHOOTING TABLE or call
1-800-235-5878.
OPERATING
THE COUPLER
This model is equipped with a coupler
which enables optional attachments to
be installed.
The optional attach-
ments are:
Edger ...............
358.792401
Cultivator
............
358.792410
Blower
..............
358.792421
Brushcutter
..........
358.792441
Pruner
..............
358.792450
_J.WARNING:
Always stop unit
and disconnect
spark plug before re-
moving or installing
attachments,
REMOVING
TRIMMER
ATTACH-
MENT (OR OTHER OPTIONAL
AT-
TACHMENTS)
CAUTION:
When removing
or instal-
ling attachments,
place the unit on a
flat surface for stability.
1. Loosen the coupler by turning the
knob counterclockwise.
Upper Shaft
Coupler
Lower
Attachment
TIGHTEN
Knob
12
Publicidad
